A1/GX Service Instructions

A1/GX: Recoil Belt Buckle Replacement

  • May 22, 2017 // Modified 8 years ago

Step 1- Pass the Recoil Belt through the bungee buckle with the belt facing the serrations on the buckle as shown.

Step 2- Pass the Recoil Belt through the D-ring and back through the bungee buckle as shown. The Recoil Belt should follow itself back through the buckle. It is advised that the loose end of the Recoil Belt be passed back through the last bar of the Recoil Buckle as shown.

Related Articles

  • Series 4: S3 to S4 Monitor Upgrade

    Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  Step 2- Stand the WaterRower upright and disconnect the bungee...

  • A1/GX: Sensor Modification

    If the machine is not registering stroke rate, but distance and time are registering, there may be an issue with the sensor placement and it may need to be slightly...

  • M1: Tank Cover Removal

    Video Instructions: Removing & Replacing the M1 Tank Cover Step 1.  Place handle into the most forward position near the Forward Riser Pulley. Step 2.  Remove the rest bolts. Step...

  • M1: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...