M1 Service Instructions

M1: Extrusion Replacement

  • May 22, 2017 // Modified 8 years ago

Step 1.  With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail.

Step 2.  Peel the old extrusion off the rail.

Step 3.  Using alcohol, remove ALL the left over adhesive. Please do not use any other solvent as it may damage the paint.

Step 4.  Once the rail surface is cleaned, attach the new extrusions. Peel away the one side of tape. Line up the seat stop holes in the extrusions to the holes in the rail. Press evenly down the length of the extrusion to adhere it firmly and smoothly to the surface of the rail.

Step 5.  With the 5mm Allen key, screw back in the rail seat stops.

Step 6.  If necessary, repeat steps 1-5 on the other rail.

Related Articles

  • Series 3: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...

  • Series 3: Full Tank Assembly Replacement

    Handle Removal Step 1.  Remove the Handle from the handle rests and place the handle in the full forward position Step 2.  Stand the WaterRower upright and disconnect the bungee...

  • Series 3: Tacho Belt Replacement

    Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee...

  • A1/GX: Forward Riser Replacement

    For Video Instructions, please see the following link: Replacing the Forward Riser Assembly Step 1- Remove handle assembly (see handle removal replacement instructions) Step 2- Remove Recoil Belt (see recoil...