M1 Service Instructions

M1: Level Gauge Location

  • May 22, 2017 // Modified 8 years ago

The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper.

The Level Gauge sticker on the A1 and Indo-Row units is located on the bottom of the tank. On the A1 and GX WaterRower units, this sticker also has the unit’s serial number printed on it. To locate your serial number, see the following page: Serial Number Locations

Advised volume for WaterRower tank:

15.223 L = 15.223 kg = 33.561 Lb = 4.021 gallons

Gives you:
“Calibration level” on A1/Indo-Row sticker and ≈ “level 17.5″ on S4 sticker

The approximate height is 14 inches off the ground when upright and 8.5 inches off the ground when placed on the ground in rowing position.

Related Articles

  • Series 4: Top Deck Replacement

    For instructions on how to replace the Top Deck on your WaterRower, check out these service instructions.

  • M1: Monitor Board Replacement

    Step 1- Remove screws (2) fastening the battery cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Battery...

  • M1: Oilite Bearing Replacement

    Step 1- Remove the Handle from the handle rests and place the handle in the full forward position. Step 2- Stand the WaterRower upright and disconnect the bungee from the...

  • A1/GX: Rail Bumper Replacement

    These rail bumpers help support bottom of the A1/GX Rear Leg. Used on; A1/GX Series Only. To order this part, head to our website: WRPR201 – A1/GX Leg Bumper Set