M1 Service Instructions

M1: Recoil Belt Buckle Replacement

  • May 23, 2017 // Modified 7 years ago

Step 1- Pass the Recoil Belt through the bungee buckle with the belt facing the serrations on the buckle as shown.

 

Step 2- Pass the Recoil Belt through the D-ring and back through the bungee buckle as shown. The Recoil Belt should follow itself back through the buckle. It is advised that the loose end of the Recoil Belt be passed back through the last bar of the Recoil Buckle as shown.

 

Related Articles

  • M1: Handle Replacement (plastic clutch)

    For Video Instructions, click here: Replacing the Handle Assembly (Plastic – Bolt On)   Step 1- Remove the handle from the handle rests and place it in the full forward...

  • Series 3: Tacho Belt Replacement

    Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee...

  • Series 4: Monitor Retrofit

    Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  Step 2- Stand the WaterRower upright and disconnect the bungee...

  • Series 4: Seat Guide Wheel Replacement

    Replace the Series 4 Guide Wheel easily by following the steps in this video: Replacing the Guide Wheels