M1 Monitor Service Instructions

M1: Monitor Sensor Disk Replacement

  • May 22, 2017 // Modified 8 years ago
Sensor Disk Replacement: View a video for this
Step 1– Remove the Handle from the handle rests and place the handle in the full forward position as shown.
  Step 2- Stand the WaterRower upright and disconnect the bungee as shown.
 Step 3- Lay the WaterRower down. Remove the Tie Rods and JCB bolts connecting the Top Deck to the Tank assembly as shown.
  Step 4- Remove the top deck assembly as shown, being careful not to dislodge the guide pulleys. You may have to disconnect the sensor wire plug.
 
Step 5- Remove the Sensor Disk as shown.
 
Step 6- Replace the Sensor Disk as shown.
Step 7- Replace the top deck as shown.
  Step 8- Replace the JCB bolts and Tie Rods connecting the Top Deck to the Tank assembly as shown. Ensure that the Tie Rod cross dowel slots are aligned with the Tie Rod. You may utilize a screw driver to assist this.
  Step 9- Stand the WaterRower upright and connect the Recoil Belt to the bungee as shown.
 
Note: If the recoil belt buckle and D-ring have been removed it will be necessary to refit them before Step 9 may be completed. Refer to the Recoil Buckle Replacement Instruction for details.

 

Related Articles

  • Series 4: Monitor Sensor Disk Alignment

    If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...

  • M1: Tank Reseal with Glue Kit

    If your tank has sprung a leak, the best way to go about repairing it is with our Tank Glue Kit. We have full written instructions as well as a...

  • Series 3: Tacho Pulley Replacement

    Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee...

  • Series 2: Footstrap Replacement (Bolt on)

    Step 1.  Remove the Footstrap bolts and Footstrap. Step 2.  Replace the Footstrap bolts and Footstrap.