M1 Service Instructions

M1: Tank Cover Removal

Video Instructions: Removing & Replacing the M1 Tank Cover

Step 1.  Place handle into the most forward position near the Forward Riser Pulley.

Step 2.  Remove the rest bolts.

Step 3.  Pivot back the footboard.

Step 4.  Remove the cover from the rower to expose the top deck.

Related Articles

  • M1: Monitor Sensor Disk Replacement

    Sensor Disk Replacement: View a video for this Step 1– Remove the Handle from the handle rests and place the handle in the full forward position as shown.   Step 2- Stand the...

  • S1: Rail Extrusion Replacement

    Step 1.  With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail. Step 2.  Peel the old extrusion off the...

  • M1: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...

  • M1: Monitor Battery Replacement

    Step 1- Remove screws (2) fastening the Battery Cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Batteries as shown. Step...