S1 Service Instructions

S1: Recoil Belt Buckle Replacement

  • May 24, 2017 // Modified 8 years ago

Step 1- Pass the Recoil Belt through the bungee buckle with the belt facing the serrations on the buckle as shown.

Step 2- Pass the Recoil Belt through the D-ring and back through the bungee buckle as shown. The Recoil Belt should follow itself back through the buckle. It is advised that the loose end of the Recoil Belt be passed back through the last bar of the Recoil Buckle as shown.

Related Articles

  • S1: Monitor Sensor Disk Alignment

    If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...

  • Series 4: Rail Extrusion Removal

    *These instructions are made for all wooden WaterRower models. This includes the Natural, Club, Oxbridge and Classic models. Step 1- With the 5mm Allen Key, unscrew the seat stops. There...

  • Series 3: Seat Replacement

    Step 1- Loosen the fasteners holding the Rear Spacer to the rails three or four turns each.   Step 2- Remove the seat.   Step 3- Replace the seat. Step...

  • Series 3: Metal Clutch Replacement

    For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...