Series 3 Service Instructions

Series 3: Recoil Belt Buckle Replacement

  • May 25, 2017 // Modified 7 years ago

Step 1- Pass the Recoil Belt through the bungee buckle with the belt facing the serrations on the buckle as shown.

 

Step 2- Pass the Recoil Belt through the D-ring and back through the bungee buckle as shown. The Recoil Belt should follow itself back through the buckle. It is advised that the loose end of the Recoil Belt be passed back through the last bar of the Recoil Buckle as shown.

 

Related Articles

  • Series 4: Top Deck Replacement

    For instructions on how to replace the Top Deck on your WaterRower, check out these service instructions.

  • Series 3: Metal Clutch Replacement

    For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...

  • M1: Monitor Sensor Disk Replacement

    Sensor Disk Replacement: View a video for this Step 1– Remove the Handle from the handle rests and place the handle in the full forward position as shown.   Step 2- Stand the...

  • M1: Short Tank Assembly Replacement

    1. Remove the handle from the handle rests and place in the full forward position. 2. Stand the WaterRower upright and disconnect the bungee. 3. Lay the WaterRower down and pull...