Series 2 Service Instructions

Series 2: Double Bungee Replacement

  • Jun 12, 2017 // Modified 2 years ago

Step 1.  Remove the Handle from the handle rests and place the handle in the full forward position.

Step 2.  Stand the WaterRower upright and disconnect the bungee from the recoil belt as shown.

Step 3.  Remove the Bungee from the rear spacer and reattach the replacement bungee as shown.
Step 4.  Reconnect the Bungee to the recoil belt as shown.If the recoil belt buckle has been removed reattach it as shown, if not go to step 5.
Step 5.  Use one hand to take the tension of the bungee and the other to support the recoil belt, feed the recoil belt through the D-ring.

Step 6.  Pass the recoil belt through back through the recoil belt buckle as shown.

Related Articles

  • Series 4: Rail Extrusion Removal

    *These instructions are made for all wooden WaterRower models. This includes the Natural, Club, Oxbridge and Classic models. Step 1- With the 5mm Allen Key, unscrew the seat stops. There...

  • M1: Short Tank Assembly Replacement

    1. Remove the handle from the handle rests and place in the full forward position. 2. Stand the WaterRower upright and disconnect the bungee. 3. Lay the WaterRower down and pull...

  • Series 3: Footboard Replacement

    Step 1-Remove the Handle from the handle rests and place the handle in the full forward position.   Step 2– Remove the handle rest bolts and handle rests as shown....

  • Series 3: Recoil Bushing Replacement

    Handle Removal Step 1- Remove the handle from the Handle rests and place the Handle in the full forward position.   Step 2- Stand the WaterRower upright and disconnect the...