Step 1. Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not to dislodge the guide pulleys. Step 3– Disconnect the Sensor Connector. Remove the old monitor retaining pin and remove the old monitor from the key …
Step 1- Remove screws (2) fastening the Battery Cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Batteries as shown. Step 4– Replace the Batteries as shown. Step 5- Replace the Battery Cover as shown Step 6- Replace the screws (2) fastening the Battery Cover at the rear of …
Step 1- Remove screws (2) fastening the battery cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Battery as shown Step 4- Remove screws (4) fastening the Monitor Board Assembly to the housing as shown. Step 5- Remove Monitor Board Assembly as …
1. Undo the bungee. 2. Use your 5mm ratchet (or Allen key) to remove the fastners from the rear end pad (or wooden spacer on wood models). 3. Slide the seat off the rails and flip the seat over so you can access the guide wheels located on the bottom of the seat. 4. Using your …
Step 1. With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail. Step 2. Peel the old extrusion off the rail. Step 3. Using alcohol, remove ALL the left over adhesive. Please do not use any other solvent as it may damage the paint. Step …
Step 1- Remove the handle from the handle rests and place the handle in the full forward position. Step 2- Disconnect the bungee as shown. Step 3- Remove the bungee from the rear spacer and reattach the replacement bungee as shown. Step 4- Connect the bungee to the recoil belt as shown.
You will need a 5mm allen wrench and a 13mm wrench. Step 1. Remove old strap. Step 2. Use the 5mm allen key and 13mm wrench to remove clamp and nuts. You will need to the 13mm wrench to hold the nut while unscrewing bolt with allen key. Step 3. Replace with new nuts, bolts …
Step 1. Remove the Handle from the handle rests and place the handle in the full forward position Step 2. Remove the handle rest bolts and handle rests as shown. Step 3. Swing the Footboard Back to access the bottom bolts. Step 4. Remove side bolts fixing the footboard to the side rails as shown. …
English
العربية
简体中文
繁體中文
Nederlands
Français
Deutsch
हिन्दी
Bahasa Indonesia
Italiano
日本語
한국어
Português
Русский
Español
Svenska
Tiếng Việt