Series 4 Service Instructions

Series 4: Seat Replacement

  • May 18, 2017 // Modified 7 years ago
Step 1- Loosen the fasteners holding the Rear Spacer to the rails three or four turns each.
 
Step 2- Remove the seat.
 
Step 3- Replace the seat.
Step 4- Tighten the fasteners holding the Rear Spacer to the rails.
 

 

Related Articles

  • Series 3: Tacho Pulley Replacement

    Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee...

  • Series 3: Footboard Upgrade

    Step 1-Remove the Handle from the handle rests and place the handle in the full forward position.   Step 2– Remove the handle rest bolts and handle rests as shown....

  • S1: Rail Extrusion Replacement

    Step 1.  With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail. Step 2.  Peel the old extrusion off the...

  • S1: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...