S1 Service Instructions

S1: Single Bungee Replacement

  • May 23, 2017 // Modified 7 years ago

For Video Instructions, please see the following link:
Replacing the S4 Bungee Assembly

Step 1- Remove the Handle from the handle rests and place the handle in the full forward position.

Step 2- Stand the WaterRower upright and disconnect the bungee from the Recoil Belt as shown.

Step 3- Remove the Bungee from the Rear Spacer and reattach the replacement bungee as shown.

 

Step 4- Reconnect the Bungee to the Recoil Belt as shown.

Related Articles

  • Series 3: Recoil Belt Replacement

    For Video Instructions, click here: Replacing the Recoil Belt Step 1- Remove the handle from the handle rests and place the handle in the full forward position Step 2- Stand...

  • Series 3: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...

  • Series 4: Top Deck Replacement

    For instructions on how to replace the Top Deck on your WaterRower, check out these service instructions.

  • Series 3: Monitor Troubleshooting

    Battery Replacement Your Series 3 WaterRower requires 4 (AA) batteries for monitor function. If your monitor does not power on, these batteries likely need replacing. The battery pack is located...