S1 Service Instructions

S1: Level Gauge Location

  • May 24, 2017 // Modified 7 years ago

The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper.

The Level Gauge sticker on the A1 and Indo-Row units is located on the bottom of the tank. On the A1 and GX WaterRower units, this sticker also has the unit’s serial number printed on it. To locate your serial number, see the following page: Serial Number Locations

Advised volume for WaterRower tank:

15.223 L = 15.223 kg = 33.561 Lb = 4.021 gallons

Gives you:
“Calibration level” on A1/Indo-Row sticker and ≈ “level 17.5″ on S4 sticker

The approximate height is 14 inches off the ground when upright and 8.5 inches off the ground when placed on the ground in rowing position.

Related Articles

  • Series 3: Monitor Troubleshooting

    Battery Replacement Your Series 3 WaterRower requires 4 (AA) batteries for monitor function. If your monitor does not power on, these batteries likely need replacing. The battery pack is located...

  • Series 3: Footboard Upgrade

    Step 1-Remove the Handle from the handle rests and place the handle in the full forward position.   Step 2– Remove the handle rest bolts and handle rests as shown....

  • Series 3: Dolley Wheel Replacement

    Step 1- Assemble the Dolley Wheel to the rail in the sequence shown.

  • M1: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...