Series 3 Service Instructions

Series 3: Footstrap Replacement (push-button)

  • Jun 07, 2017 // Modified 8 years ago

Step 1– Remove the Lock Button bolts and the Lock Button

Step 2– Remove the Foot Strap bolts and Foot Strap

Step 3– Replace the Foot Strap and the Foot Strap bolts

Foot board replacement

Step 4– Replace the Lock Button and the Lock Button bolts

Related Articles

  • M1: Extrusion Replacement

    Step 1.  With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail. Step 2.  Peel the old extrusion off the...

  • Series 3: Oilite Bearing Replacement

    Step 1- Remove the Handle from the handle rests and place the handle in the full forward position. Step 2- Stand the WaterRower upright and disconnect the bungee from the...

  • S1: Wire Harness Replacement

    Position the handle forward to the front Forward Riser pulley Carefully remove the Top Deck by removing the Top Deck bolts and upper Tie Rods. Gently lift the Top Deck up...

  • Series 4: S3 to S4 Monitor Upgrade

    Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  Step 2- Stand the WaterRower upright and disconnect the bungee...