Series 4 Service Instructions

Series 4: Rubber Feet Replacement

  • May 18, 2017 // Modified 8 years ago

Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail.

A:The rear rubber feet indentations are approximately 3 1/2” from the back of each rail.
B:The front rubber feet indentations are approximately 13” from the front of each rail.

 

Step 2- Start at the rear of the rail and attach first of four rear rubber feet. Firmly place foot and wood screw into position and tighten with a Phillips head screwdriver. Tighten until foot is fully secure [can no longer rotate by hand].
Attach 2nd, 3rd, and 4th feet in a similar manner, while ensuring each one is flush with neighboring foot/feet.
 

Step 3- Continue to the front of the rail and attach first of four front rubber feet.

Firmly place foot and wood screw into position and tighten with a Phillips head screwdriver. Tighten until foot is fully secure [can no longer rotate by hand]. Attach 2nd, 3rd, and 4th feet in a similar manner, while ensuring each one is flush with neighboring foot/feet.
 
Step 4- Follow your assembly instructions to attach rail to rower.
 

Related Articles

  • Series 4: Footstrap Replacement (push-button)

    Step 1– Remove the Lock Button bolts and the Lock Button Step 2– Remove the Foot Strap bolts and Foot Strap Step 3– Replace the Foot Strap and the Foot...

  • M1: Full Tank Assembly Replacement

    Step 1. Remove the handle from the handle rests and place the handle in the fully forward position.   Step 2. Stand the rower upright. Disconnect the bungee from the...

  • M1: Monitor Battery Replacement

    Step 1- Remove screws (2) fastening the Battery Cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Batteries as shown. Step...

  • M1: Monitor Sensor Replacement

    For Video Instructions, click here: S4 Monitor Sensor Replacement Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...