Series 4 Service Instructions

Series 4: Seat Replacement

Step 1- Loosen the fasteners holding the Rear Spacer to the rails three or four turns each.
 
Step 2- Remove the seat.
 
Step 3- Replace the seat.
Step 4- Tighten the fasteners holding the Rear Spacer to the rails.
 

 

Related Articles

  • M1: Monitor Wire Assembly Replacement

    Position the handle forward to the front Forward Riser pulley Remove the handle rest bolts from the footboard and then angle the footboard away from the tank Remove the aluminum...

  • Series 4: Clutch Replacement (Plastic)

    For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...

  • M1: Clutch Replacement (Plastic)

    For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...

  • Series 3: Recoil Bushing Replacement

    Handle Removal Step 1- Remove the handle from the Handle rests and place the Handle in the full forward position.   Step 2- Stand the WaterRower upright and disconnect the...