Series 4 Service Instructions

Series 4: Footstrap Replacement (push-button)

  • Apr 27, 2017 // Modified 7 years ago

Step 1– Remove the Lock Button bolts and the Lock Button

Step 2– Remove the Foot Strap bolts and Foot Strap

Step 3– Replace the Foot Strap and the Foot Strap bolts

Foot board replacement

Step 4– Replace the Lock Button and the Lock Button bolts

Related Articles

  • M1: Monitor Wire Assembly Replacement

    Position the handle forward to the front Forward Riser pulley Remove the handle rest bolts from the footboard and then angle the footboard away from the tank Remove the aluminum...

  • M1: Monitor Sensor Disk Alignment

    If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...

  • A1/GX: Short Tank Assembly Replacement

    Step 1. Remove the handle from the handle rests and place in the full forward position. Step 2. Stand the WaterRower upright and disconnect the bungee. Step 3. Lay the WaterRower down...

  • M1: Wire Harness Replacement

    Position the handle forward to the front Forward Riser pulley Carefully remove the Top Deck by removing the Top Deck bolts and upper Tie Rods. Gently lift the Top Deck up...