Series 3 Service Instructions

Series 3: Seat Replacement

  • May 24, 2017 // Modified 7 years ago
Step 1- Loosen the fasteners holding the Rear Spacer to the rails three or four turns each.
 
Step 2- Remove the seat.
 
Step 3- Replace the seat.
Step 4- Tighten the fasteners holding the Rear Spacer to the rails.
 

 

Related Articles

  • Series 3: Recoil Belt Buckle Replacement

    Step 1- Pass the Recoil Belt through the bungee buckle with the belt facing the serrations on the buckle as shown.   Step 2- Pass the Recoil Belt through the...

  • A1/GX: Top Deck Replacement

    For Video Instructions, click here: Removing the Top Deck Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...

  • Series 3: Monitor Troubleshooting

    Battery Replacement Your Series 3 WaterRower requires 4 (AA) batteries for monitor function. If your monitor does not power on, these batteries likely need replacing. The battery pack is located...

  • Series 2: Handle Replacement (Bolt on)

    Step 1.  Remove the Handle from the handle rests and place the handle in the full forward position. Step 2. Pass the drive strap around the large pulley and underneath...