Series 3 Service Instructions

Series 3: Single Bungee Replacement

  • Jun 08, 2017 // Modified 7 years ago

For Video Instructions, please see the following link:
Replacing the S4 Bungee Assembly

Step 1- Remove the Handle from the handle rests and place the handle in the full forward position.

Step 2- Stand the WaterRower upright and disconnect the bungee from the Recoil Belt as shown.

Step 3- Remove the Bungee from the Rear Spacer and reattach the replacement bungee as shown.

 

Step 4- Reconnect the Bungee to the Recoil Belt as shown.

Related Articles

  • S1: Monitor Board Replacement

    Step 1- Remove screws (2) fastening the battery cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Battery...

  • A1/GX: Sensor Replacement

    Step 1.  Remove the handle from the handle rests and place the handle in the full position as shown. Step 2.  Remove the top 2 tie rods and JCB bolts...

  • S1: Monitor Sensor Disk Alignment

    If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...

  • M1: Recoil Bushing Replacement

    Handle Removal Step 1- Remove the handle from the Handle rests and place the Handle in the full forward position.   Step 2- Stand the WaterRower upright and disconnect the...