Series 4 Service Instructions

Series 4: Level Gauge Location

  • May 18, 2017 // Modified 7 years ago

The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper.

 

The Level Gauge sticker on the A1 and Indo-Row units is located on the bottom of the tank. On the A1 and GX WaterRower units, this sticker also has the unit’s serial number printed on it. To locate your serial number, see the following page: Serial Number Locations

Advised volume for WaterRower tank:

15.223 L = 15.223 kg = 33.561 Lb = 4.021 gallons

Gives you:
“Calibration level” on A1/Indo-Row sticker and ≈ “level 17.5″ on S4 sticker

The approximate height is 14 inches off the ground when upright and 8.5 inches off the ground when placed on the ground in rowing position.

Related Articles

  • M1: Monitor Sensor Disk Replacement

    Sensor Disk Replacement: View a video for this Step 1– Remove the Handle from the handle rests and place the handle in the full forward position as shown.   Step 2- Stand the...

  • Series 4: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...

  • Series 3: Level Gauge Location

    The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper.   The Level Gauge sticker on...

  • Series 4: Monitor Sensor Replacement

    For Video Instructions, click here: S4 Monitor Sensor Replacement Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...